| The first thing that you need to do when replacing a | | | | disconnect the wires. Your headlight has been |
| headlight in your RV camper, is identify your | | | | removed! It is so easy that anyone can do it. |
| application. You need to determine if you have sealed | | | | Next, you will install the new, composite headlight. |
| beam headlights, composite or module OEM | | | | Begin by installing the composite grille. You should |
| headlights. If you have sealed beam headlights, it is | | | | have about ten bolts that will hold it place. The holes |
| time to upgrade. You should be using halogen by | | | | are pre-drilled at the factory and should line up, |
| now. Next, identify what bulb you will need. If you | | | | perfectly. Once your grille is in place, you are ready |
| are upgrading from sealed beam headlights, buy | | | | to install your composite headlights. You will need to |
| HELLA conversion headlights. They have the best | | | | cut the wires that were connected to the old |
| that there is. They are made of glass instead of | | | | headlights. There should be black, green, and brown |
| plastic. They are a little more expensive than the | | | | wires. Then, cut the wires on the new, composite |
| others, but they are well worth the buy. You will | | | | headlights, also. To connect the wires together, twist |
| need to know the size of your lamps. You want to | | | | the black wires together, twist the green wires |
| measure the height and width of the lamp. If you | | | | together, and then twist the green wires together. |
| buy HELLA, it will come with a dust cap and a bulb. | | | | The black wires are your ground wires. The other |
| First, you must remove the sealed beam headlights | | | | two colored wires will work the HI and LOW beams |
| that are on your RV camper. The only tool that is | | | | on your RV Camper. To make sure that the wires do |
| needed for this is a "phillips head" screwdriver. Once | | | | not fall apart, place a wire nut on each one. |
| you have that, you are ready to get started. Begin | | | | Last, mount the headlight assemblies to your RV |
| by unscrewing the headlight bezel. There will be two | | | | Camper. They should fit just right. Test to make sure |
| screws at the top and two screws at the bottom. | | | | the lights are working, properly. You are ready to get |
| After unscrewing the bezel, remove the lamp and | | | | back on the road and go camping! |